1. OPERATING
INSTRUCTIONS
FORCING
SCREW
1) Remove all fastners from
bearing cups.
2) Slip the U-Joint Puller over
the yoke of the driveline.
3) Turn the tool's forcing screw
Eliminates clockwise with either a hand
damage to or impact wrench. (Note:
driveshaft,
GLOVE reverse thread)
yokes, cups
FORK
and bearings. 4) Once bearing cup has been
removed, repeat the process
The leg design allows you to push on on the remaining bearing
the driveline or on the U-Joint cross. cups.
(works either way on virtually any
size or model of U-Joint) The 10102 U-Joint Puller may be
DRIVESHAFT used with up to a 1-inch impact
YOKE wrench without voiding warranty.
BEARING
CUP
OPERATING
INSTRUCTIONS OPERATING
1) Ensure all parts to be assembled INSTRUCTIONS
are clean and/or greased where 1) Remove any original nuts and/or
applicable. cotter pins from parts to be
2) Double check all needle bearings separated.
are present and placed correctly. 2) Select correct tool according to
3) Start pressing bearing cup into thread size of tie rod.
yoke by hand, making sure u-joint 3) Spin the tool completely onto the
cross and bearing cup bolt holes threaded arm.
line up. 4) Back tool off one complete turn
4) Place installer onto bearing cup, backwards.
threading bolts into yoke. 5) Strike the remover with a
5) Using an impact or hand wrench, hammer; tie rod will become
turn forcing screw until cup is loose.
flush to yoke. 6) Remove tool and part to be
6) Remove tool, and install bearing removed will drop off.
cup bolts.
Lubrication: Use Prolong “Anti Friction Metal Treatment” on threads and Prolong “Superlube Grease” on load bearing
surface in glove. For information on Prolong Super Lubricants please call us.

2. OPERATING INSTRUCTIONS
1) Remove Clevis from the end of the Slack Adjuster with
the Tiger TG393 Brake Clevis Pin Press.
2) With the forcing screw backed out, slip the puller onto
the Slack Adjuster.
3) Turn the forcing screw by hand or with an impact
wrench.
4) Slack Adjuster will drop off when free.
Do not use over ½ inch impact wrench. Doing so will
void warranty.
OPERATING INSTRUCTIONS
1) Back forcing screw out.
2) Pull back spring-loaded plunger and slip tool over clevis.
3) Turn forcing screw with hand or impact wrench.
4) Tool will shear cotter pin, but remaining pieces may have to be
removed by hand.
5) When pin is free of clevis, back out forcing screw and remove tool.
Do not use over ½ inch impact wrench. Doing so will void warranty.
Lubrication: Use Prolong “Anti Friction Metal Treatment” on threads and Prolong “Superlube Grease” on load bearing
surface in glove. For information on Prolong Super Lubricants please call us.