This presentation is a first attempt at making brackets with systems easier to understand. I may be revising after suggestions and typos etc. If you have any comments regarding this presentation please reach out with questions to alibia.devente@gmail.com
4. TraxxWorksurface Brackets Page 316 Important: Brackets must be specified separately and sold individually. 1 3/16” needs support every 48”. 1 9/16” needs support every 60”. Brackets have an anti-kick-out design that provides secure attachment. A variety of additional supports such as angel brackets and support panels are used from Footprint. Images taken from pricelist and installation instructions. .
5. Storage spacing with Traxx Brackets can easily be spaced any place along the traxx rails. Spacing is located behind the pedestal to accommodate the worksurface brackets.
13. CetraWorksurface Brackets Important: Brackets must be specified separately and sold individually. 1 3/16” needs support every 48”. 1 9/16” needs support every 60”.
15. Cetra Edge Support Brackets Page 449 (Footprint) Edge brackets are handed depending on where you are standing, facing the panel. Edge brackets at corner locations are not specific to hand of bracket. Images taken from installation instructions.
16. Cetra Cantilever Page 450 (Footprint) Cantilevers are handed. Flat brackets are sold individually however must be used in pairs with a cantilever when located at the seam of two surfaces. Images taken from installation instructions.
23. Interworks EQ Worksurface Brackets Important: Brackets must be specified separately. 1 3/16” surfaces need support every 48” 1 9/16” surfaces need support every 60” Cantilevers are handed. Flat brackets are sold individually however must be used in pairs with a cantilever when located at the seam of two surfaces. Edge brackets at corner locations are not specific to hand of bracket.
25. Interworks EQ Cantilever Page 450 (Footprint) Important: Brackets must be specified separately. Cantilevers are handed. Flat brackets are sold individually however must be used in pairs with a cantilever when located at the seam of two surfaces. Consider placing pedestal fillers behind pedestals to fill gap.
26. Interworks EQ Edge Support Brackets Page 449 (Footprint) Important: Brackets must be specified separately. Edge brackets at corner locations are not specific to hand of bracket. It is not recommended to place edge brackets in the center of runs this image simply conveys all possible locations.
27. Interworks EQ Overhead Brackets Overview Wood/ Laminate overheads cannot be hung on Interworks EQ. Bevel profile overheads have a back bracket. Overhead Brackets Page 520 (Footprint) Ganging Brackets Page 523 (Footprint) .
28. Interworks EQ Flat and Bevel Profile Overhead Brackets Page 524 (Footprint) You will not find a bracket for this overhead is apart of the construction. Ganging brackets are sold in a quantity of 4. .
29. Interworks EQ Lunar Profile Overhead Brackets Page 524 & 526 (Footprint) A set of overhead brackets is need for each overhead regardless of width. Ganging brackets are sold individually .
31. Xsite Worksurface Support Page 446 All brackets are specified separately. Edge support brackets have the ability to adjust in ¼” increments up to ¾”. Top caps should be cut around transaction counter brackets. Mid-adjustable support can not be used as sole support at the end of the run. INTERWORKS
32. Xsite Page 330 Brackets are placed every 48” for 1 3/16” and 60” for 1 9/16”. INTERWORKS
Go over the items used in the example at the bottom and what it would look like specified on the computer.Surface support panels in wood, laminate or metal should be set 1” from the wll for molding or wires.