scientific and engineering e-journal publication TuEngr.com group. International Transaction Journal of Engineering, Management, & Applied Sc iences & Technologies publishes wide spectrum research and technical articles as well as reviews, experiments, experiences, modelings, simulations, designs, and innovations from engineering, sciences, life sciences, and related disciplines as well as interdisciplinary/cross-disciplinary/multidisciplinary subjects. Original work is required. Article submitted must not be under consideration of other publisher for publications.
Presentation on how to chat with PDF using ChatGPT code interpreter
How to publish your paper in international journals
1. How to publish your
paper in international
journals
Boonsap Witchayangkoon, PhD
Executive Editor
@ TuEngr.com
2. The right scientific journals for quality work::
•American Transactions on Engineering &
Applied Sciences (ATEAS)
• International Transaction Journal of
Engineering, Management, & Applied
Sciences & Technologies (ITJEMAST)
Focused as eJournalsDr.Boonsap Witchayangkoon
3. Originality
•Your work must not have been
previously published
•Your work must not have been
submitted to other publisher at the
same time
•Sign copyright transfer (with emails
of all authors)
Dr.Boonsap Witchayangkoon
4. Publish or Perish
•Effective presentation of your work
•Write clearly
– Clean & clear writing
•Discuss critical aspects
•Helps from colleagues to read/check
– One from the same research field
– One from other research field
Dr.Boonsap Witchayangkoon
5. •All submitted manuscripts will be
reviewed independently by three
individuals who have an
understanding and appreciation of the
academic peer review process and
the respective standards.
•The majority of reviewers must
recommend for publication. A
successful peer review note is added
to the end of the published article.
Peer Review:
Dr.Boonsap Witchayangkoon
6. Peer Review
•Peer-review process (4-10 Weeks)
•Editor cannot guarantee the exact
publication time as the process may
take longer time, subject to peer-
review approval and adjustment of
the submitted articles.
Dr.Boonsap Witchayangkoon
8. Figure and Table
•All figure and table must be
mentioned in writing, by referring to
each figure/table.
•example:
–All coefficients in Table 5 are from
simulation.
•Do not use "the above Table" or "the
Figure below."
Dr.Boonsap Witchayangkoon
9. Figure and Table
•Use clear graphic
•Modern journals – place Figure /
Table near where it is mentioned.
Dr.Boonsap Witchayangkoon
11. • The nomenclature section should be
inserted between the abstract and the
introduction.
• Symbols is listed in alphabetical order within
each of the following groups: English group first,
then Greek, subscripts, and superscripts.
Numbers and other symbols should be listed last.
• If the nomenclature section exists, no need to
give definitions scattered throughout the text.
• Acronyms is defined in the text, not in the
nomenclature.
Nomenclature and Symbols
Dr.Boonsap Witchayangkoon
12. References
•New up-to-date information should
be used, authors should cite newest
references sources as possible.
•Important All references must be
mentioned in the writing, and vice
versa.
•Make sure all references are correct.
•Only references are used, not
bibliography, not footnote.
Dr.Boonsap Witchayangkoon
13. Plagiarism – Ethical Aspects
Whole or partial imitation(s) of previous
works as your own original works are
considered plagiarism, especially through
cut and paste process – to have multiple
work(s) published in multiple publications
when little / no new information /
knowledge is added. Author(s) who
reuse(s) substantial parts of their own
published work without providing the
appropriate references is considered self-
plagiarism.
Dr.Boonsap Witchayangkoon
14. Malpractice statement
•Plagiarism (& self-plagiarism) is
checked before a manuscript
gets published. If plagiarism is
detected, the manuscript will be
rejected and the author(s) is(are)
put on the blacklist.
Dr.Boonsap Witchayangkoon
15. Malpractice statement
• If plagiarism of a published article is found,
Editor or Editorial Board Member(s) will
officially contact the authors' institute(s)
and funding agencies, informing such
academic misconducts.
• Plagiarism note with online (multiple) link(s)
to same elsewhere published article(s) or
plagiarized material(s) is explicitly
displayed. Either clear plagiarism mark(s)
will be added to the published article(s) or
plagiarized article(s) is(are) retracted.
Dr.Boonsap Witchayangkoon
16. Editorial Policy
• Papers of research reports and articles
with scientific research merit will be
judged for publication under careful
consideration from international
reviewers. Such research reports and
articles include those containing
substantial supported theories, innovative
works, substantial experimental results
and/or containing useful and constructive
discussions or reviews standardized to
regional or international acceptance.
Dr.Boonsap Witchayangkoon
18. Open-Access E-Journals
•Entirely unrestricted access
•UK Wellcome Trust:: “the benefits of
research are derived principally
from access to research results”
•Free to read / save / distribute
Dr.Boonsap Witchayangkoon
19. •Unrestricted reuse
– Licensees may copy, distribute,
display and perform the work and
make derivative works based on it
only if they give the author or
licensor the credits in the manner
specified by these.
Open-Access E-Journals
Attribution (by)
Dr.Boonsap Witchayangkoon
21. ACCEPTANCE VS REJECTION
•Carefully read the review result
•Accept: “Lucky you for the great job"
•Accept with revision: “Let’s do some
minor improvements."
•Revise and resubmit: “Your work still
get some attention!"
•Reject and resubmit: “The Editor still
want your paper!"
Dr.Boonsap Witchayangkoon
22. Take a chance to learn
•Believe in high quality work
•Do not fear
•Do not panic
•No angry: more rejections,
more experiences
Dr.Boonsap Witchayangkoon
23. PUT IN TEMPLATE
& TURN IT IN
TuEngr.com
MIT Libraries, USA
Standford University Library, USA
24. THANK YOU
TuEngr.com
American Transactions on
Engineering & Applied
Sciences
International Transaction Journal
of Engineering, Management,
& Applied Sciences
& Technologies
Dr.Boonsap Witchayangkoon