2. Lab 05 Objectives
• The student will be able to
– Open an existing project
– Create a new simulation profile
– Run a simulation and view the Probe output
– Modify the Probe ranges and grids for the X Axis and Y Axis
– Create a new project
– Create a new simulation for Bias Point Analysis
– Configure the schematic to display node voltages and branch currents
February 2004 ELEC 101 Lab 5 2
4. Lab 5A Requirements
• Open Circuit from Disk
• Create a New Simulation Profile for AC Sweep Analysis
• Place a ground referenced VDB Marker
• Run the simulation
• View Probe Output
• Change the X Axis grid markers to make readings more
accurate
• View Probe Output and make further modifications if desired
February 2004 ELEC 101 Lab 5 4
26. Lab 05C Overview
• In some cases we wish to determine an operating point
– this is called the Bias Point
• When Bias Point Simulation is performed in PSpice, it does
not generate a Probe Output because no component values are
swept.
• After running the simulation, close the probe Window and
Select V or I from the toolbar to have Capture display all node
voltages or all the branch currents.
• The student will Place a Net Alias (special text inserted in the
schematic) to identify nodes of particular interest
February 2004 ELEC 101 Lab 5 26