This document provides information about a training seminar held at the Deen Bandhu Chhotu Thermal Power Plant in Yamuna Nagar, Haryana, India. It introduces the power plant and provides details about its installed capacity, land area, location, contractors, timeline and coal sources. It then describes the key equipment used at the plant, including steam turbines that convert steam pressure into energy, generators that produce electricity, a chimney, cooling tower, and boiler feed pumps.

1. TRAINING SEMINAR
Training carried at:
DEEN BANDHU CHHOTU THERMAL POWER PLANT
Yamuna Nagar – 135001
Submitted To:-

2. HPGCL at a Glance
Haryana is one of the forerunners to initiate reforms in its power
sector in 1997. Pursuant to these reforms the State Electricity
Board was unbundled and reorganised on August 14,1998.
HPGCL was incorporated as a company on 17th March, 1997 and
was given the responsibility of operating and maintaining State’s
own generation projects. Various projects are as follows:
1.Deen bandhu chhotu ram thermal power plant , yamunanagar
2.Rajiv gandhi thermal power plant , hisar
3.Panipat thermal power plant , panipat
4.Wyc hydel power plant , yamunanagar

3. DEEN BANDHU CHHOTU RAM
THERMAL POWER PLANT
YAMUNANAGAR

4. INTRODUCTION
Installed Capacity 2 X 300 MW
Available Land 1107 acres
Location Yamunanagar
EPC Contractor M/s Reliance Energy Ltd, Noida
EPC Cost Rs 2097 crore ( Total estimated cost Rs.2400
.
crore)
Administrative approval 22.07.2002
Coal Sources Central Coal Fields
Revised Zero date of Project 20.08.2005
Synchronization 300 MW Unit – 1 : 13.11.2007
300 MW Unit – 2 : 29.03.2008
Trial Operation Completed 300 MW Unit – 1 : 14.04.2008
300 MW Unit – 2 : 24.06.2008

7. TRAINING SECTION
Turbines & Generators -2

8. Turbine & its Details
Steam Turbine: Basically we use steam turbine to convert
the pressure energy into mechanical energy .
Type: Stationary Steam Reaction turbine , with HP&
IP ,LP double flow
Specifications:
Calculated Load : 300MW
Main Steam Temp. : 538 C
Main steam pressure : 16.7 Mpa
Reheat steam Temp. : 538 C
Speed : 3000 rpm
Feed water temp : 275.8 C
Steam flow : 926.61 T/hr

9. WORKING PRINCIPLE OF TURBINE
RANKINE CYCLE

10. SCHEMATIC DIAGRAM
OF
POWER GENERATING
CYCLE

13. Generator & exciter
type : two pole cylindrical rotor type synchronous machine
coupled with steam turbine
Specifications (GENERATOR):
Rated output : 300 MW
Rated current : 10189 A
Power factor : 0.85 lagging
Speed : 3000 rpm
Frequency : 50 HZ
Phase : 3 Phase
Excitation : brushless

14. chimney
Height of chimney : 290 m
Amount of concrete used : 44000
tonnes

15. cooLinG toWer
Def: A cooling tower extracts
heat from water by evaporation
type : naturaL drauGht
cooLinG toWer
heiGht : 130 m

17. BOILER FEED
PUMP
Def: A BFP (boiler feed pump ) is a
device which is used to feed the
water to the boiler
It is the largest water pump I the
thermal power plant
It consumes about 4% of the total
of electricity produce in plant

18. Any
QUERIES ?