ADVANTAGES OF THE AYS MECHANICAL SLACK ADJUSTER

2. THE DIFFERENCES BETWEEN A STANDARD MECHANICAL SLACK ADJUSTER AND
THE AYS MECHANICAL SLACK ADJUSTER
Mechanical
Shaft
Mono – Block
Shaft
Worm Gear
STANDARD IMPROVED
DESIGN DESIGN
DISADVANTAGE OF THE STANDARD DESIGN :
 In the first case, the worm gear is assembled to mechanical shaft via close fit.
The problem that the worm gear can be released while equipment is working because of production method has been
observed in this type of mechanical slack adjuster.
ADVANTAGE OF THE IMPROVED DESIGN :
 This problem has been eliminated using Mono – block shaft in AYS mechanical slack adjusters.
Service life of the equipment has been extended with this production method.

3. THE DIFFERENCES BETWEEN A STANDARD MECHANICAL SLACK ADJUSTER AND
THE AYS MECHANICAL SLACK ADJUSTER
The
Standard
Mechanical
Body with
Holes
AYS
Mechanical
Body
STANDARD BODY REINFORCED BODY
DISADVANTAGE OF THE STANDARD BODY :
 Lower body strength because of holes on the body.
ADVANTAGE OF THE REINFORCED BODY :
 Reinforced body and the long service life.

4. THE DIFFERENCES BETWEEN A STANDARD MECHANICAL SLACK ADJUSTER AND
THE AYS MECHANICAL SLACK ADJUSTER
M 36 Cover
Mechanical
Locking
Locking Ball Washer
Compression Compression
Spring Spring
STANDARD DESIGN ADVANCED DESIGN
LOCKING LOCKING
DISADVANTAGE OF THE STANDARD DESIGN LOCKING :
 The weak locking system;
Two – point locking,
Diameter of the compression spring wire is 1,3 mm,
ADVANTAGE OF THE ADVANCED DESIGN LOCKING :
 Advanced locking system;
Five – point locking,
Diameter of the compression spring wire is 3 mm.
Long service life,

5. THE DIFFERENCES BETWEEN A STANDARD MECHANICAL SLACK ADJUSTER AND
THE AYS MECHANICAL SLACK ADJUSTER
O-Ring
1 2
Roller Roller
STANDARD IMPROVED
DESIGN DESIGN
DISADVANTAGE OF THE STANDARD DESIGN :
 There is no any protection part on the roller in order to protect equipment;
Low service life,
ADVANTAGE OF THE IMPROVED DESIGN :
 Mechanical slack adjuster is protected against water and any foreign matter which comes from outside by o-rings;
Long service life,

6. THE DIFFERENCES BETWEEN A STANDARD MECHANICAL SLACK ADJUSTER AND
THE AYS MECHANICAL SLACK ADJUSTER
Mechanical
Shaft
Mono Block
Shaft
O-ring
STANDARD IMPROVED
DESIGN DESIGN
DISADVANTAGE OF THE STANDARD DESIGN :
 There is no any protection part on the mechanical shaft in order to protect equipment;
Low service life,
ADVANTAGE OF THE IMPROVED DESIGN :
 Mechanical slack adjuster is protected against water and any foreign matter which comes from outside by o-ring;
Long service life,