Electrets can be very cheap and of poor quality yet they are now available at modest cost for the home music producer, and will result in stronger audio tracks. Learn about their design, their special benefits and disadvantages, and their application for Youtubes in particular.
HMCS Max Bernays Pre-Deployment Brief (May 2024).pptx
Electret microphones and music production
1. Electret Microphones:
The Musician’s Friend
Created by Clarice Stasz for assignment in
Music Production taught by Loudon Stearns,
Berklee School of Music, www.coursera.org,
2013
2. Electrets are based on Condenser
Microphones, which are known to be
Less sturdy than dynamic mics
Preferred studio mic
Offer larger frequency response for collecting
partials than dynamic mics
Require phantom power
3. Invented 1962
Gerhard Sessler and James West at Bell Labs
Developed to improved telephone communications.
4. DEFINITION
“An electret microphone is a type of
condenser microphone, which eliminates the
need for a polarizing power supply by using a
permanently charged material.”
http://en.wikipedia.org/wiki/Electret_microphone
9. Do you make Youtubes?
Electrets are in your laptop and portable
phone.
They consist of about 9o% of microphones in
use today.
Their quality is surprisingly good for many
purposes.
10. Time for a new recording mic?
Your computer mic is fine for everyday uses,
like Skype, taking audio notes.
Music on the same mic may sound tinny
because of distortion and limited response.
You sound better than what you hear.
11. Benefits of electret
Very inexpensive, under $1 for lowest quality,
hence popular with gearheads
Suits voice recording well
Extremely wide frequency response (from
10Hz to 30kHz ) in best cases.
Sample inexpensive electret
12. Technically superior
This is according to the technical sound
engineer papers . The electret design is
supposed to be the most accurate transducer.
Of course, this will be affected by the quality
of the production. Nonetheless,
theoretically, electrets should be the best.
13. A look inside one type
Being condensors, they need power so some
include an amp.
http://sound.westhost.com/project93.htm
14. Others include a battery and
then connect to the amp.
www.caitches.com
15. Electrets have a bad reputation with some
Vibrating membrane can wear out in a couple
of years
More fragile overall than a dynamic mic
Cheap models mean poor quality
Some users find the bass range
unsatisfactory
16. Disadvantages of lower
quality (cheap) models
Output impedance is relatively high
Relatively low sensitivity
Noise is relatively high
Sound level handling ability is low,
typically < 90 dBSPL
17. Home recording
Today you can find
good quality electrets
for under $50, with the
specs you need in
terms of pickup
pattern, frequency
Stereo ominidirectional
with direct plugin to response, and more.
minimize vibration
18. Performing mics as well.
This looks like a
dynamic mic.
It’s an electret
specifically for
vocalists to reduce
pops, optimize lower
frequency response,
and minimize
distortion. It is also a
cardioid design.
19. One pro’s experience
“The cheap electret mics polarize the
diaphragm. This is cheap to make but results in a
diaphragm that's quite thick (maybe 20 microns
or so).
A back-electret puts that charge on a sheet
that's between the backplate and the
diaphragm. With this arrangement, you can use
a normal diaphragm thickness… so it may be
difficult to tell the difference between an electret
and an externally polarized condensor mic in
performance - that gap is narrowing.”
From “Dale” on Gearslutz.com.
20. Recommendations
For spoken word or singing with a single
instrument, your computer mic could be just
fine
For higher quality, and ability to make finer
mixes before uploading, explore quality
electrets now widely available at moderate
prices.
For performing, because electrets are
technically the purest transducer, you may
want to try one out.
21. In other words…
Where ten years ago people said the electrets
were lousy for serious sound work, this is no
longer true.
Major microphone firms make professional
level electrets, up into hundreds of dollars.
Given the same price and specs, the back-
electret design is your better choice.
22. Connecting to computer
This is a topic in itself. Try these for help:
http://manual.audacityteam.org/man/Tutoria
l_-_Connecting_a_Microphone
http://www.ehow.com/how_6362940_connec
t-electric-condenser-microphone-pc.html
http://support.apple.com/kb/HT2508
23. Self-evaluation
As a result of this project, I learned:
Three of my music-based mics are electrets:
flute, ukulele, and Sony mini-stereo
recording.
It is worth using an external electret for my
laptop for quality recording.
A lot of sound reference materials require
some engineering background to
comprehend. I definitely missed some
understanding in putting this together.
24. If I had more time,
I’d have sound samples with various mics to
demonstrate differences
I’d use Camtasia to make a video from this
PowerPoint with an audio track added
In that last case, I’d reduce all the written
slides and have more visuals. For example, I’d
open up a mic to show the parts.
25. If you evaluate this….
Don’t hesitate to note
errors,
Or to suggest additions.
ukestasz@gmail.com