1. Rear Window Tinting Austin Tips
A rear curved window can be Tinted by cutting a few long strips and applying them
one at a time, overlapping them just slightly at the edges. Then, if you want a real
professional Window Tinting Austin job, trim the overlapped edge with a razor blade,
being careful not to cut the rear window defogger wire in the process. If you have a
hatchback, you might opt to remove the hatch to tint it and then reinstall it. You can
do the same with the side windows, as this allows you to lay them flat on a table to
do your work. It's an option. This brings up another point. All the comers should be
radiused rather than sharp, or the film will have the tendency to pull up if it
encounters anything. To radius the corner, just twist the X-Acto knife as you pull it, or
use a coin for a cutting guide and trim around the coin while holding it against the
glass.
With your pieces cut to precise size, apply the film by spraying the window with the
soap solution. Then set the film on the glass as carefully as possible, matching the
shape of the window for alignment. Using a squeegee, start from the center and
work your way outward, being sure not to trap any bubbles or dust under the film. If
you do you can lift that area, remove the obstacle, and reapply the film. This is the art
to Window Tinting Austin and the part that will show the difference between an
amateur and a professional job. The material is not that expensive, so it you ruin a
sheet, start over with a new sheet. But you will have to clean the glass before you
start again, as it will have adhesives you will want to remove. Plan a half a day for this
and turn off the cell phone.
For more information about Window Tinting Austin – Click Here