1. EXPERIMENT NO 4
You have just been asked to build a lab network to test new configurations that will
be rolled out to your production networks.
Host A on left should be setup with ip of 192.168.101.2/24 and a default gateway of
192.168.101.1/24
Host B on right should be setup with ip of 192.168.100.2/24 and a default gateway of
192.168.100.1/24
R1(Router)
Ethernet Interface 192.168.101.1/24
Serial interface 192.168.1.1/24
R2(Router)
Ethernet Interface 192.168.100.1/24
Serial interface 192.168.1.2/24
We have DCE cable connected at R1 with speed of 64K
R1
Router>enable
Router#configure terminal
Enter configuration commands, one per line. End with CNTL/Z
Router(config)#interface s0/0
Router(config-if)#ip address 192.168.1.1 255.255.255.0
Router(config-if)#clock rate 64000
Router(config-if)#no shutdown
10:15:54 %LINK-3-UPDOWN: Interface Serial0/0, changed state to up
10:15:54 %LINEPROTO-5-UPDOWN: Line protocol on Interface Serial0/0, changed
state to up
Router(config-if)#exit
Router(config)#interface f0/0
Router(config-if)#ip address 192.168.101.1 255.255.255.0
Router(config-if)#no shutdown
10:17:09 %LINK-3-UPDOWN: Interface FastEthernet0/0, changed state to up
10:17:09 %LINEPROTO-5-UPDOWN: Line protocol on Interface FastEthernet0/0,
changed state to up
Router(config-if)#exit
R2
Router>enable
Router#configure terminal
Enter configuration commands, one per line. End with CNTL/Z
Router(config)#interface s0/0
Router(config-if)#ip address 192.168.1.2 255.255.255.0
Router(config-if)#no shutdown
10:15:54 %LINK-3-UPDOWN: Interface Serial0/0, changed state to up
2. 10:15:54 %LINEPROTO-5-UPDOWN: Line protocol on Interface Serial0/0, changed
state to up
Router(config-if)#exit
Router(config)#interface f0/0
Router(config-if)#ip address 192.168.100.1 255.255.255.0
Router(config-if)#no shutdown
10:17:09 %LINK-3-UPDOWN: Interface FastEthernet0/0, changed state to up
10:17:09 %LINEPROTO-5-UPDOWN: Line protocol on Interface FastEthernet0/0,
changed state to up
Router(config-if)#exit
