Vacuum system

1. Vacuum System
Por: Stiven Pinzon

2. Vacuum Pressure
Gyro pressure gauge, vacuum gauge, or
suction gauge are all terms for the same gauge
used to monitor the vacuum developed in the
system that actuates the air driven gyroscopic
flight instruments.

3. In some aircraft, all the gyros are vacuum,
pressure, or electrically operated.
while the electrical system provides the power
for the turn coordinator.

4. The vacuum or pressure
system spins the gyro by
drawing a stream of air
against the rotor vanes to
spin the rotor at high
speed, much like the
operation of a
waterwheel or turbine.

5. The amount of vacuum or pressure required
for instrument operation varies, but is usually
between 4.5 “Hg and 5.5 “Hg.

6. one source of vacuum
for the gyros is a vane-type
engine-driven pump
that is mounted on the
accessory case of the
engine. Pump capacity
varies in different
airplanes, depending on
the number of gyros.

7. Shaft
rotor
case
Vane
Inlet
Oulet

8. typical vacuum system consists of an engine-driven
vacuum pump, relief valve, air filter,
gauge, and tubing necessary to complete the
connections. The gauge is mounted in the
aircraft’s instrument panel and indicates the
amount of pressure in the system (vacuum is
measured in inches of mercury less than
ambient pressure).

10. Operation
 air is drawn into the vacuum system by the
engine-driven vacuum pump. It first goes through
a filter, which prevents foreign matter from
entering the vacuum or pressure system. The air
then moves through the attitude and heading
indicators, where it causes the gyros to spin. A
relief valve prevents the vacuum pressure, or
suction, from exceeding prescribed limits. After
that, the air is expelled overboard or used in other
systems, such as for inflating pneumatic deicing
boots.

12. Important
To monitor vacuum pressure during flight,
because the attitude and heading indicators
may not provide reliable information when
suction pressure is low.
Some aircraft are equipped with a warning
light that illuminates when the vacuum
pressure drops below the acceptable level.

13. Mal funcionamiento
When the vacuum pressure drops below the
normal operating range, the gyroscopic
instruments may become unstable and
inaccurate. Checking the instruments
routinely is a good habit to develop.