The document provides instructions for programming a FabISP in-circuit programmer in Ubuntu. It lists the steps to install the necessary AVR software tools using the terminal, locate the firmware file, clean and build the firmware, fuse and program the FabISP, and verify it is working correctly by checking the USB devices listed in lsusb. The overall process involves installing software, navigating files, compiling code, and programming the FabISP chip.

1. FAB ACADEMY 2012
ASSIGNMENT
Make the FabISP in-circuit programmer
FELIX LIBIO

2. Milling

9. Soldering

17. Programming

18. Finally we proceed to program in Ubuntu, this requires having the AVR software.
Source: http://www.as220.org/fabacademy/tutorials/05.html
Open the terminal by typing sudo apt-get install flex byacc bison gcc libusb-dev
avrdude this to enter Administrator mode.
then:
sudo apt-get install gcc-avr, put Y = yes.
then:
sudo apt-get install avr-libc
then:
sudo apt-get install libc6-dev
To locate the firmware file we have to go to the Desktop:
Write or Copy cd Desktop /
then:
Ls + Enter, to locate the firmware folder
then:
Firmware + Enter
then:
Ls + Enter

19. Program the Fab ISP (Ubuntu and Mac):
make clean
make hex
sudo make fuse
sudo make program
To Verify That Your ISP is working correctly:
lsusb
If your Fab ISP has been successfully
programmed, you should see a list of the
USB devices plugged into your computer.
The Fab ISP will be listed in a line like the
following: