2. I began by importing my image to the software. I did this by
saving the image as a JPEG and then Importing it into the
document. I then used the shape tool to creat a rectangle at
the bottom left where I put a quote in that my feature (Jake
Banks) had said using the text tool.
3. Next, I added another quote Jake had said and a stand first. I also had
the name of Jake written in the top right corner, so the audience
knew who the article was about if they didn't already. I added a byline
in same text at the bottom right of my image to prove it was me who
produced this.
4. Finally, I added the article, that I had originally copied up on word after the
interview took place. I made sure that my article was in three columns so it
would all fit, also it matched the codes and conventions of other
magazines that I had done research on that were similar to mine. I
introduced a drop capital after into my article at the top, and the text was
written in 10pt. I imported the text by copying it from word, and then
importing it by pasting it into the ready made columns on the right page of
my double page spread.The last thing I did was added the page number
and my title to mark the page and the bottom right.
