1. EXPERIMENT NO 3
Using Basic Commands of network simulation
When we double click a router a console appear. On pressing enter we enable the USER
prompt. Now we write command ENABLE and press enter to enter ENABLE prompt.
2. Router>
Router>enable
Router #
In User mode all files are available but editing of these files is not possible.
#show version : This command gives which version of OS ,memory,RAM,etc
#configure terminal : For opening configuration mode.
(config)# interface S0/0/0 : Is used for configuring any interface. We can configure
serial interface as well as fast Ethernet interface using the command.
(config-if)# ip address <ipaddr> <subnet mask> : Is used to assign ip address and
subnet mask to the interface
(config-if)# no shutdown : to make network up as by default it is down.
(config-if)# exit : To exit and configure another interface