1.
ENERGY
SYSTEMS

2.
PTF

PROCESS
“ The technology is not over complicated; plastics
are shredded and then heated in an oxygen-free
chamber (known as pyrolysis) to about 400 degrees
celsius. As the plastics boil, gas is separated out.
The fuel is then distilled and filtered. Because the
entire process takes place inside a vacuum and the
plastic is melted - not burned, minimal to no
resultant toxins are released into the air, as all the
gases and or sludge are reused to fuel.”

3.
FUEL CONVERTOR





Materials needed:ply board
oxygen exhauster
Oven box with temperature adjuster.
Screws, nuts, and bolts.





Procedure:Screw the oxygen exhauster with the ply board of the oven’s size
Then screw the ply board in one side of the Owen. And plug the
oxygen exhauster’s plug in a plug point and the same for the oven.
It is ready. Test it. Keep plastics in the oven then switch on the
oxygen exhauster, the oxygen would go out. Then keep 400°C. Keep
it inside for one hour or half an hour (depending upon the types of
plastics you are using). The name we kept for this process is PTF
process. Which means Plastic to Fuel process. Then we kept fuel
converter for the simple PTF process demonstrator.

4.
SW BATTERY POWER






A battery that takes advantage of the difference in salinity between freshwater
and seawater to produce electricity.
Anywhere freshwater enters the sea, such as river mouths or estuaries, could
be potential sites for a power plant using such a battery.
The theoretical limiting factor, is the amount of freshwater available. "We
actually have an infinite amount of ocean water; unfortunately we don't have
an infinite amount of freshwater,"
As an indicator of the battery's potential for producing power, we calculated
that if all the world's rivers were put to use, their batteries could supply about
2 terawatts of electricity annually – that's roughly 13 percent of the world's
current energy consumption.
The battery itself is simple, consisting of two electrodes – one positive, one
negative – immersed in a liquid containing electrically charged particles, or
ions. In water, the ions are sodium and chlorine, the components of ordinary
table salt.
Initially, the battery is filled with freshwater and a small electric current is
applied to charge it up. The freshwater is then drained and replaced with
seawater. Since the seawater is salty, it contains 60 to 100 times more ions
than freshwater; it increases the electrical potential, or voltage, between the
two electrodes. That makes it possible to reap more electricity than the
amount used to charge the battery. We named this energy as “SW BATTERY
POWER”. This means salt water battery power.

5.
SR PANELS

if we have a rotator attached to the solar panel and
set the timer one hour once to change its angle.
The sun angle would be entered and it would rotate
in the direction of sun resulting in more efficiency in
electricity.

6.
COW DUNG –SIMPLE ANAEROBIC
DIGESTER












Materials required:Empty can/ barrel
tubes and pipes size :NPS ⅛ to NPS 3½
collector can
electricity
Procedure:Take an empty can/barrel insert a NPS 1/8 pipe
Then attach the NP 3 ½ pipe in one side of the barrel/empty
can. In which you will insert your bio- waste.
Then connect a pipe with current to a plug
Then take a outlet from the passing pipe to a storage tank.
A simple anaerobic digester is ready.

7.
THANK YOU FOR WATCHING
BY,
G.R.AADITYA PRABHU
R.G.SUBAVARSHNI
KUMUDINI RAO
T. VINAY
A.AVINASH