7 steps are involved in sealcoating a driveway:
1. Prepare the surface by removing weeds and debris and cleaning any stains.
2. Fill any cracks or depressions in the asphalt with patching chemicals.
3. Saturate the asphalt surface with water from a hose or pressure washer and allow it to dry fully.
4. Mix the asphalt driveway sealer container thoroughly before and during application.
5. Apply the sealer in thin overlapping coats using a brush or squeegee following the manufacturer's instructions.
6. Allow at least 24 hours for the sealer to dry completely and barricade the driveway to prevent traffic during
2. Driveway sealcoating or sealing the driveway
creates a layer of cell that acts as a boundary that
keeps safe the concrete or other substrate from the
effects that cause physical damages such as effects
from sun, ice, oil, traffic, rain etc. Read this
information about sealing a driveway to preserve its
structure and appearance. Most of the service
provider from Ancaster follows the steps to give you
the optimum result
3. Equipment and materials required.
• Brush (stiffed and bristled)
• Push broom
• Asphalt driveway sealer (sealant)
• Compounds used for patching
• Oil/gas stain detergent
• Garden hose with a spray nozzle
• Pressure washer
• Materials
• Application brush
• Gloves
4. Direction:
1 Prepare the Environment
Remove any grass that has grown over the edges of
the surface and sweep it clean with a push broom.
Clean any oil or gas stains with a stiff-bristled brush
and a detergent formulated specifically for this
purpose, which can be bought at auto supply stores.
5. 2 Cracks and depressions should be
filled in.
Fill in significant cracks or depressions in the
asphalt with patching chemicals, which may be
found at home improvement stores. For these
chemicals, follow the drying time instructions on
the label.
6. 3 Saturate the asphalt
Spray the area with a thorough spray from a garden
hose or pressure washer to eliminate any dirt missed
during the sweeping procedure. Allow enough time for
the surface to dry.
7. 4 Sealants should be mixed together.
Turn the driveway sealer container upside down with
the lid closed to pre-mix the contents. Continue to stir
the sealant once it has been opened to ensure that it is
well-mixed.
8. 5 Put the Sealant on.
Pour some asphalt driveway sealer on the surface,
starting in one corner. Instead of creating lengthy
thin strips, you'll probably find it easier to work on
one tiny square portion of around 10 to 20 square
feet at a time. With a long-handled application
brush or squeegee, apply your sealant in thin,
overlapping applications. Remember that applying a
thicker coating of sealant will not provide more
protection, so follow the manufacturer's directions.
9. 6 Allow Sealant to Dry
The drying time is at least 24 hours, during which time
no traffic of any kind should be allowed on the surface.
To prevent automobile access, use barrels at the
entrance to your yard, or just use the empty sealer
tubs. Drive a post into the ground on either side of the
entryway and string some yellow construction tape
between the posts for better visibility.
10. While seal coating can help maintain a driveway, its
usefulness in extending its service life is limited. If
the original foundation was not sound, or if the soil
was clay or silty, or if the driveway has aged to the
point that there are numerous or significant cracks,
resealing may be of little value. If you are in
Ancaster and looking for sealcoating experts, then
consult an authentic Driveway sealcoating
professional in Ancaster. It is suggested that you
undergo a regular inspection once a year
