24. Keyhole-shaped fixing holes enables to be mounted to the ram and bed in a single, simple motion. Back Straightforward precision alignment www.wila.nl Quick assembly
25. Alignment in the X-direction, i.e. in relation to the back gauge, is straightforward and permanently realizable over the machine’s entire length. This can significantly increase the economic life of the press brake Back Quick assembly Straightforward precision alignment (Tx)
26. Non-deformable, one-piece body Hardened steel Maximum bending freedom Clamping possible at 10mm Specially designed clamping medium The body is fabricated from a single piece, which means that it is practically non-deformable. The special CrMo alloy provides a tensile strength of roughly 1100 N/mm2. Next part www.wila.nl
27. Non-deformable, one-piece body Hardened steel Maximum bending freedom Clamping possible at 10mm Specially designed clamping medium The clamping medium is a hose, designed specifically for this purpose. Oil is pumped into this hose onder high pressure (40-50 bar). This results in an unrivalled clamping force over the full length of the machine. Next part www.wila.nl
28. Non-deformable, one-piece body Hardened steel Maximum bending freedom Clamping possible at 10mm Specially designed clamping medium Every surface on the body which come into contact with tools is hardened to approximately 56 o Rc. This guarantees the preservation of all properties, resulting in an extremely long life. Next part www.wila.nl
29. Non-deformable, one-piece body Hardened steel Clamping possible at 10mm Specially designed clamping medium The dimensions of the body - including the rear side - are minimal. This creates an unbelievably high degree of bending freedom. Next part www.wila.nl Maximum bending freedom α > 30 O
30. Non-deformable, one-piece body Hardened steel Maximum bending freedom Clamping possible at 10mm Specially designed clamping medium Thanks to the design and spacing of the clamping pins, tool components with a minimum length of 10mm can be individually positioned and securely clamped, anywhere on the machine. Next part www.wila.nl
32. The plastic guards at both ends of the clamping system provide guidance and prevent damage during the horizontal interchange of tools. The guards can also be delivered in a flat version . Next part www.wila.nl www.wila.nl Guard
56. Hardening possibilities Nitrating Laser hardening CNC Deep hardening
57.
58.
59. Available modified Standards New standard With nose 28 º Radius R=1.5 and 2 mm With nose 60 º Radius R=2 –3-4 and 5 mm With nose 80º thru 90º R=2-3-4-5 and 6 mm