The document discusses important factors to consider when choosing a spinning can for a spinning mill. Key points include using high density polyethylene sheets for the body that are durable and prevent damage. Stainless steel should be used for the top rim and band to prevent rust. Castors should allow smooth 360-degree movement without play. Springs are critical for uniform movement and need proper specifications. The top plate material and design should securely hold sliver.

2. INTRODUCTION
Choosing the right Spinning Can is key to produce the best quality of Sliver
in a Spinning Mill. A good Spinning Can not only delivers a quality product
but also lasts for a longer time giving economic viability to the investment.
Here are 6 important points you should look for:

3. PREMIUM QUALITY HDPE SHEET
FOR A KICKING BEND.
Never compromise on the Body Sheet as it is the most exposed
part of the Spinning Can for regular wear and tear. Always go for
HDPE Sheets with Kicking Bend with Standard Thickness, Zero
Scratch Damage, Zero Ovality, Zero Overlapping, and Seamless
press at Joint.

4. STAINLESS STEEL FOR TOP RIM & BAND
We suggest using Stainless Steel for Top rim & binder to prevent rusting
and rough edges wherein sliver can accumulate & impact its quality.
Galvanized Bottom Rim and Plate in all types of Cans. Use steel rivets at
7-8 inch intervals to ensure no gap between spares and the body sheet
to avoid fiber accumulation. Use Embossed Sheets for Bottom Rims and
Plates.

5. SMOOTH 360-DEGREE CASTOR
MOVEMENT
Look for Ball Bearing Type 360-Degree Swiveling Castors, directly fixed
to the bottom plate using nut bolts. Ensure no play in the castor
movement and minimum gap from the floor.

6. USE STAINLESS STEEL WIRE WITH
PLASTIC COATING IN TYING CHORD
Use Non-Adjustable Stainless Steel wire with Plastic Coating in Tying
Chord, while binding the springs with the Bottom Plate. Keep
equidistance between three parallel chords. Do not directly tie with the
top plate.

7. SPRINGS ARE THE HEART OF THE CAN
Use coated springs for your can and check the Spring Thrust as per
specifications to avoid ununiformed movement and balance during
operations. Proper Specification with pretension value must be filled in
the specification sheet while asking from the supplier.

8. CHOOSE THE PERFECT TOP PLATE TO
HOLD THE SLIVER WELL
Top Plate should be produced in a single die. Use plastic sheets for up to
24-inch Cans and 18G Steel Sheets for up to 48-inch Cans. Use
Embossed Sheet (Radial Lines, Circular Lines and Pyramid Points) for
better grip on the spring and uniform holding of sliver.

9. THANK YOU
CONTACT US:
JUMAC MANUFACTURING
21, C.R. Avenue, Kolkata - 700071, India