Assembly instructions for the LEE Filters 100mm lens adaptor for the Olympus 7-14mm Pro f2.8 lens.

1. LEE Filters 100mm System
Olympus 7-14mm Pro f2.8
lens adaptor
Assembly
Instructions

2. The Lens Adaptor is made up of three rings:
1. Front Ring (with 4 positioning lugs)
2. Compression Ring (blue)
3. Locking Ring (fluted)
All three rings are supplied screwed together,
unscrew from each other before assembly.
Stage 1
To fix the Lens Adaptor, the lens must be off the camera.
- once fitted, it can be left permanently in place.

3. Before attaching to the lens, place the locking
ring over the blue compression ring.
Stage 2
1
2

4. Position the front ring, with
the lugs nearest to the lens
– the ring will only fit
correctly in one orientation
as the lugs are asymmetric.
Stage 3
1 2

5. You now need to turn the
lens face down; this is
easier to achieve if you use
the original cap to pin the
front ring in position.
Note: the cap will not lock in
place, it merely holds the front
ring in the correct position for
stage 5.
Stage 4
1 2

6. Introduce the locking ring and compression
ring from the rear of the lens while still holding
the lens by the cap.
Stage 5
You should then be able to tighten the lock
ring onto the front ring – do this until finger
tight, there is no need to use excessive force
and the ring should then be locked in place
with no movement or slack. 2
1

7. You are now ready to attach the LEE filter holder
when needed.
When finished, use the white LEE lens cap
(supplied) to protect the front element of the lens.
Stage 6