Company to offer complete B4/B5/B6/B7 armoring solutions in Pakistan by using renown Ballistic Steel from Manufactures. The Ballistic Material does not have any adverse affects on the smooth mobility of the vehicles
Electric Nation Upper Midwest Inter-Tribal Electric Vehicle (EV) Charging Com...
Bullet Proof & Armored tactical vehicle
1. ARMORED TACTICAL VEHICLEARMORED TACTICAL VEHICLE
A joint project for Light Weight Armored Vehicles
For Condom APC – Sindh
NOC No.F-5/20/2008-
Security-1
2. FC™ prides itself in designing and producing armored vehicles which give optimal protection
to the perceived threat level while maintaining the original appearance and performance of
the vehicle. To this end, FC™ utilizes a wide range of the most advanced ballistic materials
available today.
Before After work
4. Permission for armoring from MinistryPermission for armoring from Ministry
of Interior Govt. of Pakistanof Interior Govt. of Pakistan
September 2008 Suppression in March 2012
5. XDS LAV is designed for and fully capable of returning fire in a combat
situation, making it an excellent fighting platform. This vehicle is built with
combat procedures and military application vehicle styling in mind, and is
extremely effective in protecting convoy vehicles which are transporting
principles. However, when needed strictly for patrol, or for use in tight urban
areas where combat vehicles are normally not effective, the XDS LAV is
designed with excellent dynamic characteristics, such as braking, acceleration,
and overall handling.
IntroductionIntroduction
25. Turret for GunnerTurret for Gunner
Previous After
Armored to protect against B6/NIJ Level III assault weapons (vehicle’s
standard configuration), and designed to withstand underbody blast, the
XDS™ LAV is the ideal vehicle providing versatility, operational adjustment
and combat readiness, all in a single, cost-effective and easy to drive
platform.
41. New of XDS LAV (Reconditioning / Repairing)
XDS Achieved the success in reconditioning the damaged/ condom APC,s of Police Rangers & FC
by replacing the old Armoring technology with the latest Hi-Tech Armoring system to meet the new
challenges of current era with the budgetary limitations
XDS LAV:
Armored Vehicle Reconditioning Specification (Land Rover 110HD)
• Overall length 4.32 M (170 inches)
•Over all width 1.63 M (64 inches)
•Over all height 2.03 M (80 inches)
•Gross Vehicle Weight below 3500 kg
•Transmission Type 5 F, 1 R (Manual) (4WD)
•Minimum Turning Radius 6.6 M
•Brake System Vacuum Servo Assisted Disk Brakes
•Seating Capacity 08 (2+6)
•Suspension Heavy Duty
•Tyre Run Flat Tyres (4 in numbers)
•Steering Power Steering
• Electrical System 12 VDC, 65 AMP
• Seating Arrangement Folding Seat
•Seat Belts For driver and commander
•Transparent Armour BR Glasses against7.62 mm NATO Ball
•Revolving Light 01
•Special Tools Standard Vehicle Tools
•Colour As per requirement
•Gunner Shield 360⁰ rotation can be customized for 12.7 mm /7.62 mm
Machine Gun
46. Roof Protection Level B6
Specifications
Outer dia 40”
Inner Dia 36”
Thickness 1.175”
Without peddling
Outer PCD 3/3x12x39”
Inner PCD 3/8x12x37”
Weight 85 Kg
Specifications Remarks
Outer dia 40”
Inner Dia 36”
Thickness 1.175” Without peddling
Outer PCD 3/3x12
x39”
Inner PCD 3/8x12
x37”
Weight 85 Kg
47. Floor Protection IED Floor is fitted with Kevlar blast protection to protect
occupants against fragmentation from simultaneous detonation of IED’s and 2
DM-51 German ordnance hand grenades or equivalent.
Before After
Floor Constructed with IED Protection
49. •Additional Vehicle Modifications at Glance:
1.Mechanical Upgrades: The Engine of Toyota Land Cruiser Pick-up 4 x 4 4.2L V6 Diesel Trans: 5 Speed
Manual alterated in existing vehicle structurally modified engine compartment to compensate for the
additional weight to ensure that the car is drivable and roadworthy. Specific attention is given to the
suspension, brakes and hinges. Due to increased load on the vehicle, parts will wear sooner which can be
prevented by regular and appropriate maintenance.
2.Overhauling of chassis of existing vehicle.
3.Reinforcement of hinges and door swing straps.
4.Roof mounted turret with gun mount for PKB (7.62 x 51). & Armor précising.
5.Reinforcement substrates shall be used in necessary areas.
6.Suspension upgrade.
7.Front break system upgraded.
8.Upgraded coils/leaf springs.
9.Run flat inserts will be fitted along with replace new Tyers (05).
10.Battery protection (7.62 x 51).
11.Floor protection: Flexible multi-layered ballistic nylon is sealed to the entire floor of the vehicle. Designed to
absorb bomb and IED’s fragmentation, armor is concealed under the carpet and seats to maintain the original
appearance of each vehicle.
12.Fuel tank: Armored with mild steel and covered with XDS Composite Kavilar® for IED protection.
13.Seating system for 2+6 passengers.
14.Siren/PA system with blue & red strobes.
15.Self recovery winch.
16.External fog and search lights.
17.Internal/external communication system.
18.Locking gas cap.
19.Wire meshes tailpipe protection.
20.Upholstery of entire vehicle with Floor mats.
21.Refresh with color and design as recommended by the authority.
50. STANDARD FEATURES
STANDARD FEATURES
•Spring Actuated Light Bonnet
•Air Conditioner
•Soldier Firing Hatch
•Lifting and Towing Hooks
•Fire Extinguisher
•First Aid Box
•PA Equipment
OPTIONAL ITEM (On Request)
• Communication Equipment
• Weapon System
VEHICLE WEIGHT AND CAPACITY
•Vehicle GVWR: 3500 Kg
•Curb weight: 2800 Kg
•Payload: 1000 Kg
•Optional equipment:
•Turret with gunner protection: Included
TROOP SEATING CAPACITY*, FRONT + REAR
2+6. * - the vehicle seating capacity may be re-configured to accommodate user’s
Requirements
Transparent Armor
•Bullet Resistance Glass
•A combination of glass, polycarbonate and Mylar are bonded together using the
latest technology, producing one of the finest transparent armors available while
-Anti-spall shield protecting occupants against shattering glass
--Multiple impact protection.
-Finest optical quality, Minimal distortion, de-lamination,Anti- UV rays
- All exterior glass is shielded from larger projectiles such as rocks, bottles, grenades,
etc. by steel mesh covers which can be removed by user for cleaning and/or glass
replacement.
51. Delivery on time as contractual commitments.Delivery on time as contractual commitments.
Exhibition Ideas 2009 On time Delivery
Armoring Brochure 2013.pdf Armouring Material Flyer Design.pdf Bomb_Blanket_new.pdf