Just Call Vip call girls Kasganj Escorts ☎️8617370543 Two shot with one girl ...
Rhs level 2 certificate year 1 week 26 2012
1. RHS Level 2 Certificate
Year 1 Week 26-
Garden planning.
Site survey and plan
drawing.
2. Learning objectives
1. Site appraisal (2)
1.1 Describe how the layout of a site may be influenced by
topographical and environmental factors.
1.2 List the user requirements which must be considered
before preparing the basic outline plan of the garden.
1.3 Describe how a range of garden user requirements
should be incorporated into a basic outline plan.
2. Garden planning
2.1 Describe how to carry out basic linear surveying
techniques, including the use of tapes, offsets and
triangulation
2.2 Describe the methods used for recording surveying data.
3. Site appraisal - topography
‘Topography’ : the configuration of a surface
and the relations between its man-made and
natural features. Particularly in the design
context, the mapping of the changes in
surface level of the site.
Slopes and hollows must be recorded
accurately onto the survey plan and taken
into account in the layout of the site.
4. Measuring slopes
Taking a datum point at a known
height on the house front (bottom
of the door frame). Measure out to
a peg in the ground and mark that
level on the peg.
Take a second peg and level with
the first. Put a tall pole at the fence
bottom of the slope and use a taut
straight string line to mark where
the line meets the tall pole.
Measure down from the string line
to the ground at 1m intervals.
Record this and you are recording
how much the ground at that point
is below the datum point at the
house. This can then be plotted on
a cross section plan
5. Design responses to slopes
Terracing can be
used to make a
steeply sloping site
useable
Expensive and
requires expert
construction of
retaining walls
6. Design responses to slopes
Making a virtue of a slope – for example by
designing a stream garden with a zigzag path beside
it
7. Environmental factors in design
Prevailing wind – where should windbreaks go?
Aspect – where does the sun fall at different times of
day? Where should seating areas be positioned,
what need for shade is there?
Views – borrow favourable views and hide ugly ones.
Views into the garden – creating privacy
Soil – pH (hard to change and will therefore affect
what can be planted); depth (if insufficient then
raised beds can be used).
8. How user requirements relate to the
plan
What, Why, Where, When and Who? (not
necessarily in that order).
Once requirements are established the areas
of use can be plotted onto the plan (quiet
area, productive area etc) as can the
circulation routes that people are likely to
take.
9. Equipment needed for basic surveying
‘Chain’ – a 100ft (30m aprox.) long tape on a
reel.
A metal tape measure or folding rule
Wooden pegs
A set square
A compass
A string line (with as little stretch as possible)
A clip board, paper and pen
A spirit level (if surveying slopes)
10. Surveying techniques
Single point surveying –. Triangulation of points from
defined points (such as the corners of a courtyard). Small
areas.
Measurements along a base line – used to plot the house
outline and features
Offset measurements from a base line – used to plot
curves and features less than 8m from the base line.
Triangulation from two points on a base line – used for
fixed points in a larger area (more than 8m from the base
line).
Always orient the survey to North using the compass –
that is, record the deviation from magnetic north of your
base lines. Note that plans should be drawn with North at
the top.
11. Drawing to scale
This method ensures that the distances on the
ground are accurately represented in the correct
proportions on the plan.
Using a scale and the right size of paper means that
the entire site can be seen from above on the plan.
A scale ruler makes the conversion easy. A scale of
1:1 is actual size, 1:50 means that each centimetre
on the plan is 50cm on the ground etc.
The scale chosen should be large enough to show
sufficient detail but not so large as make the plan
unmanageable. For most gardens 1:100 or 1:50 is
appropriate
12. Drawing the plan
Having chosen the scale, plot the building first taking
the information from your survey notes. If there is no
building then draw on your base line in pencil to
scale. Plot the building or base line at the
appropriate deviation from North (North is at the top
of the page – use a protractor to measure the
degrees).
Work out from the building. To plot triangulated
points use compasses set to first one measured
length and make an arc on the paper, then set them
to the other length and make an arc. Where the two
arcs cross is the point of the feature recorded.
To plot offset points use a set square and ruler.
13. Learning outcomes
1. Site appraisal (2)
1.1 Describe how the layout of a site may be influenced by
topographical and environmental factors.
1.2 List the user requirements which must be considered before
preparing the basic outline plan of the garden.
1.3 Describe how a range of garden user requirements should be
incorporated into a basic outline plan.
2. Garden planning
2.1 Describe how to carry out basic linear surveying techniques,
including the use of tapes, offsets and triangulation
2.2 Describe the methods used for recording surveying data.