Intze Overhead Water Tank Design by Working Stress - IS Method.pdf
BOMB DETECTION ROBOT BY USING GSM & GPS
1. A Technical Project Paper Presentation on
BOMB DETECTION ROBOT BY USING GSM & GPS
by
J.SUDARSHANREDDY -117Y1A0425
DEPARTMENT OF ELECTRONICS&COMMUNICATION ENGINEERING
A1-GLOBAL INSTITUTE OF ENGINEERING
&TECHNOLOGY
(Approved by AICTE New Delhi & Affiliated to JNTU Kakinada)
Markapur – 523316. Prakasam (Dist) A.P.
2. These project main aim is to prepare bomb detecting
robot by using gsm &gps to detect the bomb and to
avoid the bomb blast.
4. In the present day scenario we are facing many threats
by bomb blasts
so our project aim is to prepare a unmanned vehicle .
5. The Aim of the project is to prepare a unmanned
vehicle which will detect the bomb.
It will not onlydetect the bomb but also position of
bomb by using gps module and the position of bomb
will intimated to the specific person by
message through gsm module.
9. The max 232 is an IC first created by maxim
integrated product in 1987 that converts signals from an
RS-232 serial port to signal suitable for use in TTL
compatible digital logic circuit.
10. Arm 7 is a family of arm processor these generation
introduces the thumb 16 bit processor set providing
improved code density compared to previous design.
The most widely used micro processor is arm 7.
The arm 7 is a low power.
11. An H bridge is an electronic circuit that enables a
voltage to be applied a cross a load in either direction.
These circuit are often used in robotics .
Most dc to ac converts
18. Not blocked by common materials: It can penetrate
most solids and pass through walls.
Longer range.
It is not sensitive to the light;.
It is not much sensitive to the environmental changes
and weather conditions
20. It is most advanced technology
It is of low cost
By using this technology we can detect the bomb as
early as possible and dismannual it easily so that we
can easily save the life of the human beings.